Farmer DiamondsUsed hard drives with statutory warranty – home page

Guides

Power-on hours of a hard drive: how many is a lot?

Power-on hours say how long a hard drive has been switched on so far. Whether that is a lot shows in comparison: with the calendar, with the other drives of the same model and with the price.

The short answer

Power-on hours are the hours a hard drive has been switched on. One year of continuous operation is 8,766 hours.

The drives we currently offer lie between 4,078 h and 27,448 h – that is 0.5 to 3.1 years of continuous operation.

We name no hour count from which a hard drive would be “too old”. Power-on hours describe how the drive has been used so far; they do not predict how long it will keep running. Our terms (A 8, in German) say the same: the measured values describe the condition at the time of testing and are no promise of a remaining service life.

Converting hours to years

Divided by 8,766, power-on hours give the years of continuous operation. Every drive page prints this conversion below the hours.

Power-on hours as years of continuous operation
Power-on hoursYears of continuous operation
8,766 h1.0
5,000 h0.6
10,000 h1.1
20,000 h2.3
30,000 h3.4

A drive that did not run without a break was in use for longer at the same hour count. How often it was started shows in its power cycles.

What is on offer right now

Per model: how many drives are available and where their power-on hours lie – the fewest, the median and the most. The median is the middle value: half of the drives have fewer hours, the other half more.

Power-on hours of the available drives per model
ModelAvailableFewestMedianMost
OOS22000G 22 TB1594,078 h0.5 years6,125 h0.7 years9,490 h1.1 years
Seagate Exos X20 20 TBST20000NM007D-3DJ1033379,071 h1.0 years13,856 h1.6 years20,147 h2.3 years
OOS18000G 18 TB311,179 h1.3 years11,202 h1.3 years11,202 h1.3 years
Seagate Exos X18 18 TBST18000NM000J-2TV1031569,926 h1.1 years17,359 h2.0 years27,448 h3.1 years
Seagate Exos X16 16 TBST16000NM001G-2KK103268,531 h1.0 years9,779 h1.1 years11,954 h1.4 years
WD Red Plus 14 TBWDC WD140EFGX-68B0GN0317,379 h2.0 years19,066 h2.2 years19,115 h2.2 years

On a model page the drives can be sorted by power-on hours and narrowed to a maximum number of hours; all hard drives can be searched the same way.

How power-on hours move the price

Every model has a base price and a reference value for power-on hours. For every 10,000 hours above the reference the price is 8% of the base price lower, for every 10,000 hours below it 4% higher – in proportion for any hour count in between.

The price always stays inside the researched price range of the model. Where the hours moved the price of a drive, its page says under “How this price is worked out” by how much and against which reference value. More: How the price is set.

Power-on hours are not everything

Beside the power-on hours, every drive carries three more measured values:

  • Power cycles: how often the drive was started. They complement the power-on hours and do not move the price.
  • Bad sectors: a measured zero does not move the price. Measured bad sectors lower it by 25% of the base price, a value that was not recorded by 10%.
  • Self-test: a passed long self-test raises the price by 5% of the base price; without a recorded self-test it is 5% lower.

What each of these values means is explained under Measured values of a used hard drive.

What “not recorded” means

Where no power-on hours were recorded for a drive, it says “not recorded” – never a zero and never an estimate. Sorted by power-on hours, such a drive comes last, and a filter on a maximum number of hours leaves it out.

Power-on hours that were not recorded do not affect the price: there is neither a surcharge nor a deduction for them. More under “not recorded”.